7007 Carriage CARRIAGE: position register not accurate All This error should not be reported during normal operation. An attempt has been made to move the carriage to a position, but the position register is not accurate. The carriage position register is initialized automatically when necessary by sending the carriage to the home switch at the beginning of a command. It may be possible to cause this error using monitor commands. If this error occurs during normal operation (i.e. no monitor commands used) a firmware bug should be reported. If this error occurs while using a monitor command, the "carriage init" command should be used before attempting the command again. Record error message and contact Creo service Carriage commands issued through the diagnostic monitor Currently unknown firmware or hardware bug ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:32:28 2008 PST